BMW B47 Engine Oil Type & Capacity: Correct Spec, Litres and Best Oil for UK Drivers

You're standing over the bonnet with a bottle of oil in your hand, or you're about to order a 5-litre drum online, and you're not sure it's the right one. Fair enough. Two numbers matter: the oil spec and the capacity. Get either wrong on a modern diesel and you can end up with a clogged DPF, a worn chain or a very expensive bill.
The short answer: most BMW B47 engines take around 5.5 litres of oil at a service fill (with a filter change). The oil must carry the right BMW Longlife approval, usually LL-04 or LL-12 FE on 2016-2018 cars. Always check your handbook or filler cap against your exact car.
At voguetechnics.co.uk, our Grays, Essex workshop services B47-powered cars every week. This guide covers the specs, the litres, the best oil choices and what a service should cost.
What Oil Does the BMW B47 Engine Take, and Which Spec Matters?

The B47 is BMW's 2.0-litre four-cylinder turbo diesel. It powers the 1 Series, 2 Series, 3 Series (320d), 4 Series, 5 Series (520d), X1 and X3, plus many MINI diesels. It replaced the older N47, which has its own well-known weak spot. If you're comparing the two, our [internal link: BMW N47 engine problems guide] explains the difference.
When people search for the BMW B47 engine oil type, they usually want one answer. But the BMW B47 engine oil spec is more important than any viscosity number. BMW approves oils against its own Longlife standards, and these are the ones that apply to diesels:
BMW approval | Typical viscosity | Where it fits |
| LL-04 | 0W-30, 5W-30, 0W-40, 5W-40 | Low-SAPS oil that protects the DPF; widely used on B47 cars |
| LL-12 FE | 0W-30 | Fuel-economy oil for selected diesels from around 2014 |
| LL-17 FE+ | 0W-20 | Permitted only on certain diesels from around 2021 |
| LL-19 FE | 0W-30 | Newer diesel spec from 2022, recommended for many LL-04 applications |
These are the BMW B47 engine oil specifications in plain terms. Which one your car needs depends on its age and engine variant. Never choose by viscosity alone.
Is BMW B47 0W-30 or 5W-30 the Right Choice?
This is one of the most common questions we get. BMW B47 0W30 or 5W30? Both can be correct, depending on the approval printed on the bottle.
- 0W-30 (LL-12 FE or LL-19 FE): flows faster on a cold start, which helps protect the engine during the first few seconds. It's a good fit for cars whose handbook calls for a fuel-economy approval.
- 5W-30 (LL-04): a proven, widely available choice on cars specified for LL-04. It's often cheaper and easy to find.
Why does it matter? On a diesel with a DPF, the wrong oil can leave ash in the filter and shorten its life. Thin, low-quality or non-approved oil can also speed up wear in the turbo and timing components. Cheap oil often turns out to be the most expensive part of an engine repair.
Rule of thumb: match the approval in your handbook first, then pick the viscosity within that approval.
What Is the Best Oil for the BMW B47 Engine in the UK?
The best oil for a BMW B47 engine is the one that carries your car's exact BMW approval, from a brand you can trust, in date and sealed. Here are the choices we see most often:
Option | Typical grade and approval | Best for |
| Genuine BMW Twin Power Turbo | 0W-30 or 5W-30, LL-04 or LL-12 FE depending on the product | Owners who want a guaranteed match and a documented service |
| Major-brand synthetic (Castrol, Shell, Liqui Moly, Ravenol and others) | Check the label for your exact BMW LL approval | Good value, provided the approval is printed on the bottle |
| Generic "universal" oil | Often lacks BMW approvals | Avoid on a B47 |
Before you buy oil yourself, check three things on the label:
- The BMW Longlife approval (LL-04, LL-12 FE and so on) is printed on the bottle, not just "suitable for BMW".
- The viscosity matches your handbook.
- The oil is low-SAPS (ACEA C3 or similar), which protects the DPF.
If the bottle is missing any of these, put it back on the shelf.
What Is the BMW B47 Engine Oil Capacity by Model and Year?

Next to the spec, capacity is the question we hear most. The BMW B47 engine oil capacity is around 5.5 litres for a service fill with a new filter, according to published data for 1, 3 and 5 Series cars. Some sources quote slightly less, around 5.0 litres. That small gap is why you should always confirm against your handbook before you pour.
How Many Litres of Oil Does a BMW B47 Take in the 320d, 520d (G30) and X1?
The BMW B47 oil capacity is broadly the same across the range, because it's the same engine. The BMW G30 520d engine oil capacity is also listed at around 5.5 litres for the service fill.
Model | Engine | Approx. service-fill capacity |
| BMW 118d / 120d | B47 | About 5.5 litres |
| BMW 318d / 320d (F30, G20) | B47 | About 5.5 litres |
| BMW 518d / 520d (G30) | B47 | About 5.5 litres |
| BMW X1 / X3 diesel | B47 | About 5.5 litres |
| MINI diesel (B47 variants) | B47 | Check the handbook |
Treat these as a guide, not gospel. The exact B47 engine oil capacity can vary slightly by variant and by how much oil stays in the system.
Practical tips for topping up and checking:
- Don't guess the level. Most B47 cars use an electronic oil level check through the iDrive menu, so follow the car's own procedure.
- Add in small amounts. Pour in 0.5 litre at a time, wait, then recheck.
- Never overfill. Too much oil can foam, stress the seals and damage the turbo.
Scenario we see a lot: an owner tops up "just to be safe" and ends up well above the maximum. The result is oil smoke and a failed emissions check. A measured top-up avoids that.
Does the B47 Oil Type Change Between 2016, 2017 and 2018 Cars?
Usually the answer is no, but check anyway. Here's how it works:
- 2016 BMW B47 engine oil type & capacity: typically LL-04 or LL-12 FE, with a capacity of around 5.5 litres.
- 2017 BMW B47 engine oil type & capacity: the same approvals apply, with the same capacity. Some variants differ, so confirm.
- 2018 BMW B47 engine oil type & capacity: again LL-04 or LL-12 FE, around 5.5 litres. Later cars (especially from 2021 onwards) may be approved for newer specs such as LL-17 FE+ or LL-19 FE.
How to find your car's exact spec:
- Check the owner's handbook and the service book.
- Look at the oil filler cap for any approval markings.
- Ask a BMW specialist to run your VIN against BMW's records.
Where Can You Get a BMW B47 Oil Change Near Grays, Essex?

If you'd rather leave it to someone who does this every day, here's what to expect.
How Much Does a BMW B47 Oil Service Cost, and What Does It Include?
Prices vary by garage, oil brand and car. As a rough guide, an independent specialist oil service for a B47 will usually cost less than a main dealer. Please check our current price list or ask for a quote, as these figures change.
A proper service should include:
- Correct-approval oil in the right quantity
- A new oil filter and sump plug seal
- Service-indicator reset
- A quick health check of the engine and DPF area
Option | What you get | Watch out for |
| DIY | Lowest cost if you have the tools and the knowledge | Wrong spec, overfill, no service record |
| Independent specialist | Correct oil, proper records and local advice | Choose someone who names the approval they use |
| Main dealer | Brand-approved service and records | Usually the highest price |
How often should you change it? BMW's own schedule is condition-based, and some sources quote intervals up to 25,000 km. In UK driving, with short trips, traffic and cold starts, many owners prefer to change the oil sooner. A yearly service, or roughly every 10,000 miles, is a sensible and cost-effective way to protect the turbo, the DPF and the timing components.
Why Choose voguetechnics.co.uk for B47 Oil Changes in Essex?
Here's how we work in Grays:
- Approved oil only. We name the exact approval we use, so you know what's in your engine.
- Clear quotes. You'll see the cost before we start.
- Proper diagnostics. We'll flag early signs of EGR, DPF or chain trouble while the car is on the ramp.
- Local service. We cover Grays, Thurrock and the surrounding Essex area.
FAQs About BMW B47 Engine Oil Type & Capacity
What oil does a BMW B47 engine take?
It takes oil with the right BMW Longlife approval, commonly LL-04 or LL-12 FE on 2016-2018 cars. Always confirm against your handbook.
How much oil does a BMW B47 take?
Around 5.5 litres for a service fill with a new filter, though some sources quote a little less. Check your car's exact figure.
Is BMW B47 0W-30 or 5W-30 better?
Neither is better in general. Use whichever your car's approval allows. 0W-30 flows faster at startup, while 5W-30 LL-04 is a long-established choice.
What is the BMW G30 520d engine oil capacity?
About 5.5 litres at a service fill, per published data for the B47 5 Series.
Can I use 0W-20 in a B47?
Only if BMW approves it for your exact car. LL-17 FE+ 0W-20 is permitted on certain diesels from around 2021, not on older ones.
How often should I change BMW B47 oil?
BMW's service system is condition-based, but for typical UK driving, a yearly change or about 10,000 miles is a sensible, cautious interval.
Can I mix different oils in my B47?
In an emergency, a small top-up of a compatible approved oil is better than running low. For a proper fill, use one approved oil.
What happens if I use the wrong oil in a BMW B47?
You risk a clogged DPF, extra wear and a possible warranty or repair dispute. Use an approved oil.
Final Thoughts
The right BMW B47 engine oil type and capacity comes down to two checks: the approval on the bottle and the litres in the sump. Match the spec to your car's handbook, pour the correct amount, and service it on time. That's the cheapest way to protect a good engine.
If you'd rather have it done properly, contact voguetechnics.co.uk in Grays, Essex to book your B47 oil service or request a quote.


